hello Adafruit people
I am currently modding my tr 606 ( confused machine mod )
I have 2 a questions for the bassdrum mod
question no 1
on the confused machine site it says:
3. Remove Resistor "R56" and replace with a "470k" resistor. Now solder a wire between "R56" (the side the connects with "C16"), going to the point on the circuit board between Capacitor "C23" and "C24" (where they both meet).
going to the point on the circuit board between Capacitor "C23" and "C24" (where they both meet).
Do I need to scratch to pcb a bit ( remove the green) and make a solder point in the middle of the line.?
or can I simply solder R56 the C23 or C24 ( since they are connected together)
question no 2
9. Now you need to solder another "10k" resistor between "Pin 3" of IC5 and the positive 15V+ power supply. The easiest place to find the 15v+ is at "Pin 8" of IC5.
So Will it be ok if I simply solder the resistor between Pin 3 and Pin 8 of the IC.
On this post picture ( picture 23 ) I do not see a solder resistor on the pcb
Did I missed something here?
Cheers
hope this make sense
best regards
tr 606 confused machine mod guidance needed !!!
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
-
- Posts: 3
- Joined: Fri Apr 26, 2013 3:11 pm
tr 606 confused machine mod guidance needed !!!
Last edited by rqckmounted on Sat Apr 27, 2013 8:45 am, edited 1 time in total.
-
- Posts: 3
- Joined: Fri Apr 26, 2013 3:11 pm
- x-11
- Posts: 14
- Joined: Mon Jan 05, 2009 9:39 pm
Re: tr 606 confused machine mod guidance needed !!!
Hi rqckmounted,
question 1:
Yes solder it to the connection where the both caps meet.
question 2:
Yes try to make it a fast solder (to protect the ic)
peace:)
question 1:
Yes solder it to the connection where the both caps meet.
question 2:
Yes try to make it a fast solder (to protect the ic)
peace:)
Please be positive and constructive with your questions and comments.