Hi All...
I have a board with screw terminals that are 3.5mm pitch, so i am olooking for a pin strip with pine spaced at 3.5mm (0.1378 inch) to make a test harness. Lots of googleing, no luck. Has anyone ever seen anything like this?
Thanks...
Looking for 3.5mm (0.1378 in) pin strip
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- zener
- Posts: 4567
- Joined: Sat Feb 21, 2009 2:38 am
Re: Looking for 3.5mm (0.1378 in) pin strip
Phoenix Combicon from DigiKey. Just search for 3.5mm pin headers. Then pick "in stock" vertical and unshrouded
- jarcher
- Posts: 64
- Joined: Sun Mar 27, 2011 2:49 am
Re: Looking for 3.5mm (0.1378 in) pin strip
Wow, thanks! I searched DigiKey for over an hour too. You must have the magic search terms Thanks again!
Jim
Jim
Please be positive and constructive with your questions and comments.