laser cut plywood project box question.
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 1645
- Joined: Sat Nov 10, 2007 12:59 am
laser cut plywood project box question.
so would it be a bad idea to laser cut wooden cases for electronic projects on account of the carbon residue? i was thinking of cutting a plywood case for a beaglebone but it would be a drag if things started shorting out. guess i could sand and seal the edges, but i'm really lazy.
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: laser cut plywood project box question.
I wouldn't expect any problems with it. On the parts I've had done, there is surface scorching, but little if any that will rub off. If you are concerned, a light spray of shellac will seal it and dry in a few minutes.
- pburgess
- Posts: 4161
- Joined: Sun Oct 26, 2008 2:29 am
Re: laser cut plywood project box question.
Nylon standoffs/washers might help too, so nothing on the board contacts any char.
Please be positive and constructive with your questions and comments.