Motor Driver connections.

General project help for Adafruit customers

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
MohitJindal
 
Posts: 10
Joined: Mon Feb 04, 2013 1:01 am

Re: Motor Driver connections.

Post by MohitJindal »

Ok i will try that soon. Thanks. :D

MohitJindal
 
Posts: 10
Joined: Mon Feb 04, 2013 1:01 am

Re: Motor Driver connections.

Post by MohitJindal »

Hi; I have setup the connections and tried to run it. But the Red LED on the first photo IC.jpg is blinking. I think its due to overheating. :(
I connected PWM of motor driver board to the VCC. Is that PWM wire giving 5volt and some current to the VCC pin or VCC is giving some current to the PWM ? If I add 10k resistor in between PWM and VCC; will it stop the excess current and volts ? :?:

Locked
Please be positive and constructive with your questions and comments.

Return to “General Project help”