Im a relative beginner with Arduino and coding however I just recieved a QS30‐1 Nixie Tube Module as a gift
and I have no idea how to wire it to my Arduino Uno, I am hoping to make a clock with 4 of these modules. But before I
do that I what to know what wires go where exactly as I worried I will damage my Arduino (Nixie module runs at 170v).
This is the link to the manual I found on line
http://cnlearn.linksprite.com/wp-conten ... v2.0.0.pdf
I already have the test code from dfrobot ready to upload just need reassurance to know what plugs in where!
QS30 ‐ 1 Nixie Tube Module wiring help on Arduino Uno
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
Beep_Boop_Jellywoop
- Posts: 5
- Joined: Tue May 27, 2014 4:10 am
-
adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: QS30 ‐ 1 Nixie Tube Module wiring help on Arduino Uno
Do you have the whole module or just the nixie tube from it?
From what I can see in the datasheet, the module handles all the high-voltage stuff itself, and all you need to do is connect it to an Arduino to select the nixie elements you want lit.
From what I can see in the datasheet, the module handles all the high-voltage stuff itself, and all you need to do is connect it to an Arduino to select the nixie elements you want lit.
Please be positive and constructive with your questions and comments.