Howdy, so I just soldered the servo driver together today, and can't seem to get this a-working. Ive attached what my circuit looks like. The only hard thing to see is the cobbler end of the ground wire, which is in fact in the ground (third pin up). So when i plug in the cobbler ribbon cable, it lights up the power led, and when i plug a servo into the first (or any) slot, and then plug plug in the v+, the servo jumps a bit. But running Servo_example.py doesnt move it at all. I get no errors from the script, and it is showing up in 0x40.
If I'm wiring it wrong, I can't see how. and the lack of errors is also making my problem elusive to me.
- 20130119_224445.jpeg (255.56 KiB) Viewed 461 times