pinouts on cobbler and pi proto boards
Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/

pinouts on cobbler and pi proto boards

by tldr on Fri Jan 11, 2013 10:20 pm

i am a tad confused.

pins labeled do not connect in various raspberry pi documents, including the pi users guide by upton and halfacre, are labelled variously as 5v, 3.3v and ground on your boards. the user guide promises dire consequences should anything be connected to these pins.

where lies the truth?
"If I had known it was harmless, I would have killed it myself." - Phillip K. Dick, A Scanner Darkly
User avatar
tldr
 
Posts: 466
Joined: Thu Aug 30, 2012 12:34 am

Re: pinouts on cobbler and pi proto boards

by adafruit_support_bill on Sat Jan 12, 2013 6:51 am

the user guide promises dire consequences should anything be connected to these pins

I am not aware of any dire consequences associated with following any of our tutorials, so either they work fine, or nobody has lived to tell about it. :wink:
User avatar
adafruit_support_bill
 
Posts: 29218
Joined: Sat Feb 07, 2009 9:11 am

Re: pinouts on cobbler and pi proto boards

by adafruit on Thu Jan 24, 2013 1:06 pm

pins labeled NC in version 1 were 'settled' in version 2. only change is the i2c pins (from port #0 to port #1) and pin 21/27
User avatar
adafruit
 
Posts: 11672
Joined: Thu Apr 06, 2006 3:21 pm
Location: nyc