Pi Box-Prototyping Pi Plate Compatibility

Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Locked
User avatar
sevej
 
Posts: 2
Joined: Sat Jan 26, 2013 4:08 am

Pi Box-Prototyping Pi Plate Compatibility

Post by sevej »

Is the Adafruit Prototyping Pi Plate Kit for Raspberry Pi - ID: 801 (http://www.adafruit.com/products/801) compatible with the Adafruit Pi Box - Enclosure for Raspberry Pi Computers - ID: 859 (http://http://www.adafruit.com/products/859)?

In other words, if the Pi Plate is installed on a Raspberry Pi, will both fit into the Pi Box?

Thanks!

sevej

User avatar
pburgess
 
Posts: 4161
Joined: Sun Oct 26, 2008 2:29 am

Re: Pi Box-Prototyping Pi Plate Compatibility

Post by pburgess »

With the top lid off the case, then yes.

User avatar
sevej
 
Posts: 2
Joined: Sat Jan 26, 2013 4:08 am

Re: Pi Box-Prototyping Pi Plate Compatibility

Post by sevej »

Thanks for the reply!

Do you know of any enclosures that are tall enough for a prototype board with the lid on? I'm specifically looking for something that can house an xbee module shield.

Thanks again!

sevej

User avatar
ghanson
 
Posts: 4
Joined: Sun Mar 31, 2013 7:02 pm

Re: Pi Box-Prototyping Pi Plate Compatibility

Post by ghanson »

Glad to see this question and answer. I was hoping the Pi Box would be able to accommodate the Pi Plate. Now I'm off to see the wizard and get my order in!

Greg

Locked
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/

Return to “Adafruit Raspberry Pi® accessories”